Tire Tread Condition Tire Repair (Tubeless) Should a leak or flat tire occur due to a puncture, the tire may be repaired using a plug-type repair. If the damage is from a cut or if the puncture cannot be repaired using a plug, the tire must be replaced. When oper- ating the ATV in areas where transportation or service facilities are not readily available, it is strongly recommended to carry a plug- type repair kit and a tire pump along. 0732-649 The use of worn-out tires on a ATV is very dangerous. A tire is considered to be worn out when the depth of the tread is less than 3 mm (1/8 in.). Be sure to replace the tires before reaching this min- imum specification. Wheels 1.
Park the ATV on level ground and engage the brake lever lock. 2. Loosen the lug nuts on the wheel to be removed. 3. Elevate the ATV. 4. Remove the lug nuts. ! WARNING 5. Remove the wheel. The use of worn-out tires can be dan- gerous and can increase the risk of an accident. 6. Install the wheel and install the lug nuts. 7. Tighten the nuts in a crisscross pattern in 20 ft-lb increments to 40 ft-lb (steel wheel) or 80 ft-lb (aluminum wheel). Tire Replacement This ATV has low-pressure tubeless tires. Air is sealed by the contact surfaces of the inner wheel rim and the tire bead. If either the inner wheel rim or tire bead is damaged, air may leak.
Be extremely careful not to damage these areas when replacing tires. 8. Remove the jack. Muffler/Spark Arrester The muffler has a spark arrester which must be periodically cleaned. At the intervals shown in the Maintenance Schedule, clean the spark arrester using the following procedure. It is very important to use the proper tools when repairing or replacing tires to prevent damage to the tire bead or wheel rims. If proper tools and related items are not available, have this maintenance per- formed by an authorized Arctic Cat ATV dealer or a qualified tire repair station. ! WARNING Wait until the muffler cools to avoid burns. 1.
Remove the three cap screws secur- ing the spark arrester assembly to the muffler. CAUTION When breaking the tire bead loose from the wheel, be extremely careful not to damage the inner wheel sur- face or the tire bead. ! WARNING Use only Arctic Cat approved tires when replacing tires. Failure to do so could result in unstable operation. CF105A 73