Arctic Cat TRV — Arctic Cat TRV User Manual

2. Using a suitable brush, clean the car- bon deposits from the screen taking care not to damage the screen. 1. Rotate the bulb assembly counter- clockwise and remove from the headlight housing; then disconnect from the wiring harness. 2. Connect the new bulb assembly to the wiring harness connector; then insert into the headlight housing and rotate fully clockwise. CAUTION When replacing the headlight bulb, be careful not to touch the glass por- tion of the bulb. Grasp the new bulb with a clean cloth. NOTE: If the screen or gasket is damaged in any way, it must be replaced. CF104 To replace the taillight/brakelight bulb, use the following procedure. 1.

Remove the two screws and remove the lens cover. 3. Install the spark arrester assembly and secure with the three cap screws. Tighten cap screws to 48 in.-lb. 2. Push the bulb in and turn it counter- clockwise. Light Bulb Replacement 3. Install the new bulb by turning it clockwise while pushing in. The wattage rating of each bulb is shown in the chart. When replacing a burned bulb, always use the same wattage rating. 4. Install the lens cover. CAUTION Tighten the lens cover screws only until they are snug. Checking/Adjusting Headlight Aim CAUTION Use only specified bulbs indicated in the chart as replacement bulbs. The headlights can be adjusted vertically and horizontally.

The geometric center of the HIGH beam light zone is to be used for vertical and horizontal aiming. NOTE: The bulb portion of the headlight is fragile. HANDLE WITH CARE. When replacing the head- light bulb, do not touch the glass portion of the bulb. If the glass is touched, it must be cleaned with a dry cloth before installing. Skin oil residue on the bulb will shorten the life of the bulb. 1. Position the ATV on a level floor so the headlights are approximately 6.1 m (20 ft) from an aiming surface (wall or similar aiming surface). ! WARNING Do not attempt to remove the bulb when it is hot. Severe burns may result. To replace the headlight bulb, use the fol- lowing procedure.

ATV-0070C 74 Headlight 12V/27W (4) Taillight/Brakelight 12V/8W/27W