Arctic Cat TRV — Arctic Cat TRV User Manual

NOTE: There should be an aver- age operating load on the ATV when adjusting the headlight aim. 2. Measure the distance from the floor to the mid-point of each headlight. 3. Using the measurements obtained in step 2, make horizontal marks on the aiming surface. CAUTION 3411-968 Always replace a blown fuse with a fuse of the same type and rating. If the new fuse blows after a short period of use, consult an authorized Arctic Cat ATV dealer immediately. 4. Make vertical marks which intersect the horizontal marks on the aiming sur- face directly in front of the headlights. 5. Switch on the lights. Make sure the HIGH beam is on. DO NOT USE LOW BEAM. Electrical Output Terminals 6.

Observe each headlight beam aim. Proper aim is when the most intense beam is centered on the vertical mark 5 cm (2 in.) below the horizon- tal mark on the aiming surface. Two output terminals for electrical acces- sories are located on the front wiring har- ness and one output terminal for electrical accessories is located on the rear wiring harness. The accessory plug is located on the right side of the instrument pod. 7. Adjust each headlight by turning the adjustment knob clockwise to raise the beam or counterclockwise to lower the beam until correct aim is obtained. CAUTION Always use electrical accessories less than 180W.

Tool Storage Tray/ Battery Hold-Down A basic tool kit is provided with the ATV. CD714A Fuses The fuses are located in a fuse block under the seat. If there is any type of electrical system failure, always check the fuses first. CF157 Maintain the tool kit with the ATV at all times. NOTE: To remove the fuse, com- press the locking tabs on either side of the fuse case and lift out. The tool storage tray is located beneath the seat. It also serves as the battery hold- down. 75