Preparation For Storage CAUTION 4. Plug the hole in the exhaust system with a clean cloth. Prior to storing the ATV, it must be properly serviced to prevent rusting and component deterioration. 5. Apply light oil to the upper steering post bushing and plungers of the shock absorbers. Arctic Cat recommends the following procedure to prepare this ATV for stor- age. An authorized Arctic Cat ATV dealer should perform this service; how- ever, the owner/operator may perform this service if desired. 6. Tighten all nuts, bolts, cap screws, and screws. Make sure rivets hold- ing components together are tight. Replace all loose rivets.
Care must be taken that all calibrated nuts, cap screws, and bolts are tightened to specifications. 1. Clean the seat cushion (cover and base) with a damp cloth and allow to dry. 7. Fill the cooling system to the bottom of the stand pipe in the radiator neck with properly mixed coolant. 2. Clean the ATV thoroughly by wash- ing dirt, oil, grass, and other foreign matter from the entire ATV. Allow the ATV to dry thoroughly. DO NOT get water into any part of the engine or air intake. 8. Disconnect the battery cables (nega- tive cable first); then remove the bat- tery, clean the battery posts and cables, and store in a clean, dry area. 3.
Either drain the gas tank or add a fuel stabilizer to the gas in the gas tank. Remove the air filter housing cover and air filter. Start the engine and allow it to idle; then using Arc- tic Cat Engine Preserver, rapidly inject the preserver into the air filter opening for a period of 10 to 20 sec- onds. Install the air filter and hous- ing cover. NOTE: For storage, use a battery maintainer or make sure the bat- tery is fully charged (see Battery section in this manual). 9. Store the ATV indoors in a level position. CAUTION Avoid storing outside in direct sun- light and avoid using a plastic cover as moisture will collect on the ATV causing rusting.
CAUTION If the interior of the air filter housing is dirty, clean the area before starting the engine. 76