Deutz — Deutz 2011 Workshop Manual Level 3

Drive system W 02-03-01 2011 Note Schematic representation for measuring the con rod bearing bore at the points ”a” and ”b” in the levels ”1” and ”2”. 6 z Measure con rod bearing bore with internal measuring device. Insert internal measuring device in the con rod bearing bore. z Balance the internal measuring device respectively at the given measuring points and read the measured value at the reversal point of the pointer. Note If the measured values deviate slightly, additional measurements must be made with new bearing shells. 02 55 Check con rod bearing shell internal diameter z Unscrew nuts and remove con rod bearing cover. z Insert con rod bearing shell in the con rod.

Note - Note the assignment of the bearing shells. - The twist protection (1) must engage in the groove (2). 0312 1567 - 0138 4/8 © 11/2004 a b 1 a b 2 © 37239 0 © 37239 0 © 39324 0 © 39324 0 2 1 © 39325 0 © 39325 0