Deutz — Deutz 2011 Workshop Manual Level 3

Drive system W 02-03-01 2011 Check the con rod bearing bore z Mount con rod bearing cover on con rod. Note The numeric identification (1) on the con rod and the con rod bearing cover must be identical and be opposite each other in assembly. z Tighten nuts. 6 Note Use a twelve-edge box wrench. 02020 Prepare internal measuring device z Mount probe bolt for the appropriate measuring range in the internal measuring device. z Mount meter with approx. 1 mm pre-tension in the internal measuring device. z Set micrometer gauge to 58.50 mm. z Balance the internal measuring device between the test surfaces of the micrometer gauge and set the meter to the reversal point of the pointer to ”0”.

0312 1567 - 0138 3/8 © 11/2004 1 © 39322 0 © 39322 0 © 39323 0 © 39323 0 © 36094 1 © 36094 1