Deutz — Deutz 2011 Workshop Manual Level 3

Drive system W 02-03-01 2011 z Measure piston bolt bush with internal measuring device. Insert the internal measuring device in the piston bolt bush. z Balance the internal measuring device respectively at the given measuring points and read off the measured value at the reversal point of the pointer. Note - Piston bolt bush pressed in. - Measuring points, see schematic diagram. 02 43 z Remove and install piston bolt bush О Job card W 02-03-03 . 6 Check diameter of the piston bolt z Measure piston bolt with micrometer gauge. 02 61 Determine piston bolt clearance Example:

Note The piston bolt clearance is given by the difference between the piston bolt bush internal diameter "A" and the diameter of the piston bolt "B". Dimension "A" 26.035 mm Dimension ”B” 26.000 mm = Piston bolt clearance 0.035 mm 02 45 0312 1567 - 0138 2/8 © 11/2004 © 34770 1 © 34770 1 © 35908 1 © 35908 1