Deutz — Deutz 2011 Workshop Manual Level 3

Drive system W 02-09-03 2011 z Oil cylinder running surface, piston, piston rings and lifting bearing journal lightly. z Clamp piston rings with piston ring tensioning band (1). Note Do not turn the piston rings any more. z Set lifting bearing journal in the lower dead point. 6 Note - Note the cylinder assignment of the piston. - Note the identification (1) of the installation position on the piston base, the symbol flywheel/crankshaft must face the flywheel. - The piston ring tensioning band must lie flat on the crankcase. z Push the piston into the cylinder with the con rod. z Press the con rod carefully against the lifting journal. Note Do not jam the con rod with the crankshaft.

0312 1570 - 0138 7/8 © 11/2004 1 © 39284 0 © 39284 0 1 © 39285 0 © 39285 0 © 39286 0 © 39286 0