Drive system W 02-09-03 2011 z Install the con rod bearing cover. Note - Note the assignment of the con rod bearing cover. - The numeric identifications (1) on the con rod and the con rod bearing cover must be identical and opposite each other when assembled. - The numeric identification is facing the operating side. 6 z Tighten nuts. Note - Con rod bolts and nuts can be used a max. 5 times in case of provability, otherwise always change them. - Use a twelve-edge box wrench. 02020 z Insert oil dipstick (1). z Install oil intake pipe. О Job card W 08-04-06 . z Install cylinder head О Job card W 01-04-04 . 0312 1570 - 0138 8/8 © 11/2004 1 © 39287 © 39287 © 39290 © 39290 1 © 39219 0 © 39219 0