Crankcase W 03-08-03 2011 z Insert regulator lever shaft with roller lever (1) and tighten nuts (2). 05021 Note Note the installation position of the regulator lever shaft, the side with the long cut-out ”X” must face the opening for the lube oil pump and the shim disc. 6 z Place shims underneath the contact surface of the roller lever (1) so that the ball bearings do not touch the muff (arrows) z Insert meter in measuring bridge and position the stylus with pre-tension on the ball bearing (1). z Adjust meter to "0". 0312 1577 - 0138 16/24 © 11/2004 2 1 2 X © 39277 0 © 39277 0 1 © 39278 0 © 39278 0 1 © 39279 0 © 39279 0