Crankcase W 03-08-03 2011 z Move the measuring bridge and position the stylus on the ball bearing (1). z Read and note measured value. Note The difference between both measured values is max. 0.05 mm . To achieve the required tolerance shims of max. 0.5 mm may be placed under one stud bolt. z Compensate the tolerance by using shim discs (1) of suitable thickness. 6 z Repeat the measuring process after setting. z Unscrew nuts and remove regulator lever shaft. z Push the adjustment lever (1) onto the regulator lever shaft (2). Note Note installation position of the adjustment lever. 0312 1577 - 0138 17/24 © 11/2004 1 © 39280 0 © 39280 0 1 1 © 39633 0 © 39633 0 2 1 © 33967 1 © 33967 1