Crankcase W 03-11-01 2011 z Press in all tappets. z Pull out camshaft (1) carefully to the flywheel side. 6 Check the camshaft bearing. Prepare internal measuring device z Mount probe bolt for the appropriate measuring range in the internal measuring device. z Mount meter with approx. 1 mm pre-tension in the internal measuring device. z Set micrometer gauge to 54 mm. z Balance the internal measuring device between the test surfaces of the micrometer gauge and set the meter to the reversal point of the pointer to "0". Note Schematic representation for measuring the camshaft bearing at the points "a" and "b" in the levels "1" and "2".
0312 1581 - 0138 2/10 © 11/2004 1 © 39303 0 © 39303 0 © 34768 1 © 34768 1 a b 1 a b 2 © 37239 0 © 37239 0