Deutz — Deutz 2011 Workshop Manual Level 3

2011 Fuel system W 07-07-05 W 07-07-05 Check and set injection valves (leak fuel-less) Tools - Commercial tools Caution! After about three or four actuations of the hand lever, the spring space above the nozzle needle in the injection valve fills up with diesel fuel/test oil. Then it is no longer possible to actuate the hand lever. The nozzle lock nut must be loosened carefully before every test procedure to release pressure from the spring space. ! 8008 - Nozzle tester 8021 - Socket size 15 - Special tools 110 110 - Holder Note - Cleanliness is extremely important when working on the injection equipment.

- Only use pure test oil according to ISO 4113 or clean diesel fuel to test the injection valves. References - W 07-07-01 Check the injection valve. 6 z Remove injection valves О Job card W 07-07-01 . z Insert injection valve in holder. z Loosen the nozzle clamping nut with the long socket approx. 180° (relieve pressure) and re-tighten. 07002 Caution! Risk of injury! The fuel penetrates deep into the flesh through the nozzle jet. Risk of blood poisoning! ! z Install injection valve in the nozzle tester. © 11/2004 0312 1600 - 0138 1/6 © 36271 1 © 36271 1 © 35889 1 © 35889 1