Mack Trucks V-MAC IV — Mack Trucks V-MAC IV — спецификация (EN)

MID 128-SID 230 MID 128-SID 230 MID 128 SID 230 — BUFFERED IDLE VALIDATION SWITCH SIGNAL FMI 5 Current Below Normal or Open Circuit Failure Mode Identifier (FMI): 3 (Voltage Above Normal, or Shorted To High Source), 5 (Current Below Normal or Open Circuit) Conditions for fault code: IVS buffered signal shorted to ground or open Possible causes: Parameter Identification (SID): S230 Faulty connector Message Identification (MID): 128 Faulty VECU Circuit Description: The Idle Validation Switch (IVS) updates the Vehicle Electronic Control Unit (VECU) with the idle status. At idle, the Idle Validation Switch (IVS) is open and no voltage is applied to the Idle Validation Switch (IVS) signal input.

At approximately 5% - 100% pedal position the Idle Validation Switch (IVS) closes. Short to ground or open in signal circuit harness Reaction from Vehicle Electronic Control Unit (VECU): MIL lamp illuminated Noticeable external symptoms: Location: The Engine Management System (EMS) Module is located on the left side of the engine block and the Vehicle Electronic Control Unit (VECU) is located behind the center of the dash. No IVS limp home function for pedal position FMI 3 Voltage Above Normal, or Shorted To High Source Conditions for fault code: IVS buffered signal shorted to voltage Possible causes:

Faulty connector Faulty VECU Short to voltage in signal circuit harness Reaction from Vehicle Electronic Control Unit (VECU): MIL lamp illuminated Noticeable external symptoms: No IVS limp home function for pedal position Page 120 MID 128-SID 230