Mack Trucks V-MAC IV — Mack Trucks V-MAC IV — спецификация (EN)

MID 144-PID 86 MID 144-PID 86 MID 144 PID 86 — CRUISE CONTROL SET SPEED FMI 14 Special Instructions Failure Mode Identifier (FMI): 14 (Special Instructions) Conditions for fault code: Timeout on ACC1 message with adaptive cruise installed Parameter Identification (PID): P84 Message Identification (MID): 144 No information from the ACC (VORAD) Possible causes: Circuit Description: The Vehicle Speed Sensor (VSS) is an inductive sensor. When the vehicle is moving, the transmission output shaft speedometer gear teeth rotate past the VSS tip and a pulsed signal voltage is generated.

The Vehicle Electronic Control Unit (VECU) monitors the frequency of the signal generated by the VSS, to calculate the road speed. The air gap between the sensor and the toothed gear influences the VSS signal output and should be checked if erratic or inaccurate speedometer readings are reported. Faulty or no information from the ACC (VORAD) Faulty wiring harness Faulty VORAD ECU Reaction from Vehicle Electronic Control Unit (VECU): N/A Noticeable external symptoms: Location: The Vehicle Speed Sensor (VSS) is located in the rear of transmission, near the output shaft. N/A Page 150 MID 144-PID 86