Mack Trucks V-MAC IV — Mack Trucks V-MAC IV — спецификация (EN)

MID 128-PID 102 MID 128-PID 102 MID 128 PID 102 — BOOST AIR PRESSURE SENSOR Reaction from EMS module: MIL lamp will illuminate Failure Mode Identifier (FMI): 0 (Data Valid But Above Normal Operational Range — Most Severe Level), 1 (Data Valid But Below Normal Operational Range — Most Severe Level), 2 (Data Erratic, Intermittent or Incorrect), 3 (Voltage Above Normal, or Shorted To High Source), 5 (Current Below Normal or Open Circuit), 11 (Root Cause Not Known) Noticeable external symptoms: Engine derate MIL lamp illuminated FMI 1 Data Valid But Below Normal Operational Range — Most Severe Level Parameter Identification (PID): P102 Conditions for fault code: Message Identification (MID):

128 The Boost Air Pressure Sensor is indicating an unphysical value. Circuit Description: The Boost Air Pressure Sensor is used to monitor the pressure of the air in the intake system downstream from the turbocharger. The sensor consists of a pressure sensitive diaphragm/amplifier. Air pressure causes the sensor's diaphragm to deflect and produce an electrical signal proportional to the pressure. The diaphragm deflection signal is amplified in the sensor. The sensor's signal is monitored by the EMS Module. The EMS Module will set a fault code if the sensor signal is not within predetermined limits, or the signal is not rational. Possible causes:

Intermittent fault in the Boost Air Pressure Sensor harness Faulty Boost Air Pressure Sensor connector Boost Air Pressure Sensor failure Reaction from EMS module: MIL lamp will illuminate Noticeable external symptoms: Engine derate Location: The Boost Pressure Sensor is located in the air intake manifold. MIL lamp illuminated FMI 0 FMI 2 Data Valid But Above Normal Operational Range — Most Severe Level Data Erratic, Intermittent or Incorrect Conditions for fault code: Conditions for fault code: The Boost Air Pressure Sensor output is too high or too low. This fault will become active when the EMS Module detects that the Boost Air Pressure Sensor output is high. Possible causes:

The Boost Air Pressure Sensor is indicating an unphysical value. Intermittent fault in the Boost Air Pressure Sensor harness failure. Faulty Boost Air Pressure Sensor connector Possible causes: Boost Air Pressure Sensor failure Variable Geometry Turbo (VGT) actuator stuck. Reaction from EMS module: Wastegate stuck MIL lamp will illuminate Faulty Boost Air Pressure Sensor harness Noticeable external symptoms: Inlet air leakage Engine derate Boost Air Pressure Sensor failure MIL lamp illuminated Page 31 MID 128-PID 102