Mack Trucks V-MAC IV — Mack Trucks V-MAC IV — спецификация (EN)

MID 128-PID 110 MID 128-PID 110 MID 128 PID 110 — ENGINE COOLANT TEMPERATURE (ECT) SENSOR Reaction from Engine Management System (EMS) Module: MIL lamp will illuminate Failure Mode Identifier (FMI): 0 (Data Valid But Above Normal Operational Range), 2 (Data Erratic, Intermittent or Incorrect), 4 (Voltage Below Normal, or Shorted Low), 5 (Current Below Normal or Open Circuit), 10 (Abnormal Rate of Change) Illuminate red lamp when coolant temperature is critically high Illuminate yellow lamp when coolant temperature is moderately high Noticeable external symptoms: Parameter Identification (PID): P110 MIL lamp illuminated FMI 2 Message Identification (MID):

128 Data Erratic, Intermittent or Incorrect Circuit Description: The Engine Coolant Temperature (ECT) Sensor is a thermistor. The resistance of the ECT Sensor changes inversely to the temperature of the engine coolant. When the coolant is cold, the sensor resistance is high. As the temperature of the coolant increases, the sensor resistance decreases. The Engine Management System (EMS) Module monitors the voltage drop across the ECT Sensor. The coolant temperature signal is used to calculate fuel injection and to evaluate operating conditions of the engine coolant temperature. Examples of conditions that may cause high coolant temperature are:

thermostat failure, fan failure, heavy load, high ambient temperatures and radiator blockage. Conditions for fault code: The Engine Coolant Temperature (ECT) Sensor output is too high or too low. Possible causes: Faulty Engine Coolant Temperature (ECT) Sensor or Engine Management System (EMS) Module connector. Break in the Engine Coolant Temperature (ECT) Sensor harness Malfunctioning Engine Coolant Temperature (ECT) Sensor Reaction from Engine Management System (EMS) Module: Location: The Engine Coolant Temperature (ECT) Sensor is located on the right front side of the engine. MIL lamp will illuminate FMI 0 Noticeable external symptoms:

Data Valid But Above Normal Operational Range May affect vehicle driveability in some extreme cases Conditions for fault code: MIL lamp illuminated The Boost Temperature Sensor is indicating an unphysical value. FMI 4 Voltage Below Normal, or Shorted Low Possible causes: Possible causes: Extreme driving conditions Intermittent fault in the Engine Coolant Temperature (ECT) Sensor harness Faulty coolant thermostat Malfunctioning fan Faulty Engine Coolant Temperature (ECT) Sensor connector Blocked radiator Engine Coolant Temperature (ECT) Sensor failure Page 37 MID 128-PID 110