Mack Trucks V-MAC IV — Mack Trucks V-MAC IV — спецификация (EN)

MID 128-PPID 387 MID 128-PPID 387 MID 128 PPID 387 — EXHAUST GAS TEMPERATURE SENSOR #2/TRU: FILTER INLET TEMPERATURE Reaction from Engine Management System (EMS) Module: MIL lamp illuminated Noticeable external symptoms: Failure Mode Identifier (FMI):

0 (Data Valid But Above Normal Operational Range - Most Severe Level), 1 (Data Valid But Below Normal Operational Range - Most Severe Level), 2 (Data Erratic, Intermittent or Incorrect), 3 (Voltage Above Normal, or Shorted To High Source), 4 (Voltage Below Normal, or Shorted To Low Source), 5 (Current Below Normal or Open Circuit), 10 (Abnormal Rate of Change), 12 (Bad Intelligent Device or Component), 14 (Special Instructions) Ceased regeneration FMI 2 Data Erratic, Intermittent or Incorrect Conditions for fault code: Sensor is not rational Plausability Possible causes: Parameter Identification (PPID): P387 Harness connected to incorrect sensor Message Identification (MID):

128 Sensor failure Reaction from Engine Management System (EMS) Module: FMI 0 Data Valid But Above Normal Operational Range - Most Severe Level MIL lamp illuminated Noticeable external symptoms: Conditions for fault code: Too high multiple times Poor driveability Ceased regeneration Possible causes: FMI 3 N/A Voltage Above Normal, or Shorted To High Source Reaction from Engine Management System (EMS) Module: MIL lamp illuminated Conditions for fault code: Noticeable external symptoms: Short circuit high Ceased regeneration Possible causes: Faulty harness FMI 1 Reaction from Engine Management System (EMS) Module:

Data Valid But Below Normal Operational Range - Most Severe Level MIL lamp illuminated Conditions for fault code: Control temperature error multiple times Noticeable external symptoms: Aborted and ceased regeneration Possible causes: Cannot achieve control temperature multiple times Page 63 MID 128-PPID 387