Mack Trucks V-MAC IV — Mack Trucks V-MAC IV — спецификация (EN)

MID 128-PPID 436 MID 128-PPID 436 MID 128 PPID 436 — EXHAUST GAS TEMPERATURE SENSOR #3/TRU: FILTER OUTLET TEMPERATURE Reaction from Engine Management System (EMS) Module: MIL lamp illuminated Noticeable external symptoms: Failure Mode Identifier (FMI): 0 (Data Valid But Above Normal Operational Range - Most Severe Level), 2 (Data Erratic, Intermittent or Incorrect), 3 (Voltage Above Normal, or Shorted To High Source), 4 (Voltage Below Normal, or Shorted To Low Source), 5 (Current Below Normal or Open Circuit), 10 (Abnormal Rate of Change), 14 (Special Instructions) Poor driveability FMI 3 Voltage Above Normal, or Shorted To High Source Conditions for fault code:

Parameter Identification (PPID): P436 Short to battery on the metering side of the circuit Message Identification (MID): 128 Possible causes: FMI 0 Faulty harness Data Valid But Above Normal Operational Range - Most Severe Level Reaction from Engine Management System (EMS) Module: MIL lamp illuminated Conditions for fault code: Noticeable external symptoms: Too high N/A Too high multiple times Possible causes: FMI 4 To high temperature Voltage Below Normal, or Shorted To Low Source Regeneration temperature to high Conditions for fault code: Reaction from Engine Management System (EMS) Module:

Short to ground on the metering side of the circuit MIL lamp illuminated Noticeable external symptoms: Possible causes: None Faulty harness Sensor failure FMI 2 Reaction from Engine Management System (EMS) Module: Data Erratic, Intermittent or Incorrect MIL lamp illuminated Conditions for fault code: Noticeable external symptoms: Sensor is not rational None Plausability FMI 5 Possible causes: Harness connected to incorrect sensor Current Below Normal or Open Circuit Sensor failure Page 65 MID 128-PPID 436