MAINTENANCE WARNING WEAR GOGGLES, SAFETY SHOES, HARD HAT, WORK CLOTHES AND WORK GLOVES TO PERFORM INSPECTION AND MAINTE- NANCE ON THIS MACHINE. 4.7 120 HOUR INSPECTION & MAINTENANCE PRO- CEDURES. A. CONTROL LEVER JOINT LUBRICATION Remove the rubber boots from control levers and lubricate the universal joint 1 and the top of the sliding area 2 every 120 hours. See Figure 4.35A. B. SWING MOTOR REDUCTION OIL Check the oil level of the swing motor reduction unit on a new machine after the first 50 hours of engine operation. Then check every 120 hours. 1. Locate the dipstick on the side of the swing motor. See Figure 4.36B. Pull dipstick, wipe clean and reinsert all the way in. 2.
Pull dipstick and read oil level. 3. If necessary to add oil, remove plug from oil fill port and fill to full level with proper oil. See Fig- ure 4.36B and refer to page 4-11 for oil specifi- cations. 4. Check and make sure the vent hole on dipstick is clean. See Figure 4.36C. FIGURE 4.36A FILL PLUG DIPSTICK 4 CAUTION FIGURE 4.36B SK32004082 Reduction unit may be under pressure. Remove plug slowly. 5. To drain any excess oil from swing motor re- duction Unit: a. Locate drain port under the center opening of the lower frame. See Figure 4.36D. b. Place a an empty container under drain port and remove plug allowing excess oil to drain into container. Total oil volume FIGURE 4.36C c.
Replace plug and tighten securely after all oil is drained. d. Fill through fill port using proper oil. See Fig- ure 4.36B and Refer to page 4-11 for oil specifications. e. Recheck oil level and make sure it is within specifications. WARNING NEVER PERFORM MAINTENANCE ON A MACHINE THAT HAS JUST FINISHED WORKING. ALLOW SUFFICIENT TIME FOR MA- CHINE TO COOL DOWN. SK32004083 DRAIN PORT FIGURE 4.36D 4-36 SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2 KEEP CLEAN FULL MARK MODEL Volume SK210 (LC) -VI 7.5 Liter (2.0 Gal) SK250LC-VI 15.3 Liter (4.0 Gal)