Kobelco — C. CHANGE HYDRAULIC OIL 4-

MAINTENANCE 10. Install special suction stopper Part Number 24100P978F2 over suction tube inside hydrau- lic tank. See Figure 4.49A. HYDRAULIC TANK 11. Slowly remove the six retaining bolts from the hydraulic return filter cover plate. See Figure 4.49B. SUCTION STOPPER ASSEMBLY PART No. 24100P978F2 12. Remove “O”-Ring, bypass valve, and filter ele- ment from hydraulic tank. See Figure 4.48B SUCTION TUBE 13. Place a 156 liter (41 Gal) capacity container under drain plug. Remove plug and allow all oil from hydraulic tank to drain into container. See Figure 4.49C. SK32004107 FIGURE 4.49A 14. After all oil has drained, carefully and thoroughly clean inside of hydraulic tank. BOLT 15.

Replace hydraulic tank drain plug and tighten securely. SPRING WASHER COVER O-RING 4 16. Inspect return filter and oil for signs of abnor- mal wear. SPRING 17. Clean hydraulic tank covers, spring, and bypass valve. BYPASS VALVE 18. Install a new return filter element Part Number YN50V00001P1, along with the Bypass Valve and spring, as shown in Figure 4.49B. FILTER NOTE Order element kit P/N YN50V00004F3, which consists of one filter P/N YN50V00001P1, and “O” - ring seal P/N ZD11G20000. For machines equipped with Breaker, or- der return filter P/N YN50V00009P1. 19. Remove special suction stopper from suction tube. FIGURE 4.49B BOTTOM OF HYDRAULIC TANK CAUTION Clean up all spilled oil.

Dispose of all hazardous waste in accordance with government environmental regula- tions. DRAIN PLUG SK32004110 FIGURE 4.49C SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2 4-49