Kobelco — C. CHANGE HYDRAULIC OIL 4-

MAINTENANCE C. CHANGE HYDRAULIC OIL NOTE The following procedures are to be used for a normal oil change of the hydraulic tank oil only. HYDRAULIC OIL CHECK POSITION SK32001028 If it is necessary to change the hydraulic oil viscosity, change hydraulic oil due to hydraulic component failure or change main pump, contact an authorized KOBELCO Dealer Service Department for assistance. FIGURE 4.48A Remove cap to release hyd. tank pressure WARNING BE CAUTIOUS OF HOT FLUIDS AND SURFACES. WEAR GOGGLES, SAFETY SHOES, HARD HAT, WORK CLOTHES AND WORK GLOVES TO PER- FORM INSPECTION AND MAINTENANCE ON THIS MACHINE. ALLOW HYDRAULIC OIL TO COOL BE- FORE CHANGING.

4 FIGURE 4.48B SLOWLY REMOVE BOLTS AND COVER 1. Move the machine to a firm, level surface with the attachment in the hydraulic oil check posi- tion. See Figure 4.48A. Make sure the attach- ments are resting on the ground. NOTE If the machine is cold, warm the hydraulic oil. See Sec- tion 3 (Basic Machine Operation) for specific instructions. FIGURE 4.48C BOLT 2. Shut off the engine. SPRING WASHER COVER 3. Turn the ignition key to the “ON” position - DO NOT START THE ENGINE. O-RING 4. Make sure the safety lever is in the unlocked (down) position. SUCTION STRAINER 5. Move the attachment control levers, several times in all directions. 6. Release hydraulic tank pressure. See Fig. 4.48B. 7.

Slowly remove the six retaining bolts from the suction strainer cover plate. See Fig. 4.48C. Remove strainer and remove its “O”-ring. 8. Remove cover, “O”-ring, and strainer from hy- draulic tank. See Figure 4.48D. 9. Remove the “O”-ring from the bottom of the strainer. See Figure 4.48D. FIGURE 4.48D 4-48 SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2