Kobelco — B. REMOVAL AND INSTALLATION OF RADIATOR 4-

MAINTENANCE B. REMOVAL AND INSTALLATION OF RADIA- TOR WARNING BE CAUTIOUS OF HOT FLUIDS AND SURFACES. WEAR GOGGLES, SAFETY SHOES, HARD HAT, WORK CLOTHES AND WORK GLOVES TO PERFORM INSPECTION AND MAINTENANCE ON THIS MACHINE. ALLOW SUFFICIENT TIME FOR THE ENGINE TO COOL BEFORE CHANGING FLUIDS. 1. Move the machine to a firm level area, place the attachments on the ground, and shut off the en- gine. 2. Raise the engine hood and make sure to lock it open. See Figure 4.47A. Place a rag or paper towel on the radiator cap and slowly open it to release any pressure. FIGURE 4.47A DEBRIS SCREEN RADIATOR 3.

On the SK210(LC) -VI, remove the two wing nuts 1 and the radiator top cover (between the ra- diator and the oil cooler, see Fig. 4.47B). On the SK250(LC)-VI, remove the two wing nuts that hold the debris screen in front of the radiator and remove the screen. 4 OIL COOLER 1 4. Locate the lower cover beneath the radiator. See Figure 4.47A. Remove bolts and cover to obtain access to the radiator drain hose. Place an empty container, with sufficient capacity for engine sys- tem coolant, below the radiator drain hose. Re- fer to page 4-10 for proper system capacity. Turn valve counter clock wise to open drain. FIGURE 4.47B 5. Loosen four M8 cap screws 2 and remove side pads 3 from the R.H.

and L.H. sides of the ra- diator shoulders. See Fig. 4.47C. 6. Remove four M10 capscrews 4 from the top of radiator, two from each side. 7. Remove two M8 capscrews 5 from the lower side of radiator. See Fig. 4.47C. 8. After making sure that the cooling mixture is com- pletely drained out, loosen the radiator hose clamps 6 , and remove hoses from the radiator side only. See Fig. 4.47C. 9. Move the radiator toward the oil cooler side, and remove it paying attention not to damage the insulation. See Fig. 4.47C. The radiator weights 29 kg (64 lbs) 10. After cleaning the radiator, install it by following the reverse procedure described above.

NOTE Refer to pages 4-10 and 4-11 for radiator capacity and proper coolant mixture. FIGURE 4.47C SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2 4-47 LOCK COVER OPEN REMOVE RADIATOR CAP