Kobelco — A. ENGINE COOLANT CHANGE 4-

MAINTENANCE 4 4-46 SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2 5. Remove the engine lower cover. See Figure 4.46A. Use a funnel with hose attached to di- rect the drained coolant toward the container. 6. Locate the engine coolant drain plug on the left side of the engine block. Remove it to drain coolant. See Figure 4.46B. 7. After draining, close the drain valve and in- stall the drain plug. Fill cooling system with REMOVE BOLTS AND COVER PLATE with fresh water, preferable with hot water. FIGURE 4.46A 8. Start engine and bring engine cooling tem- perature to about 90 ºC (194 ºF). Then run Radiator expansion tank Thermostat engine at low idle.

Remove engine drain plug, open radiator drain valve, and simultaneously Drain plug feed fresh water into radiator until draining water comes out clear (About 10 min. flush- Vent ing should be sufficient). hose 9. When flushing is completed, stop engine and Bypass also stop water feeding. Drain engine cooling Rad. core Cooling gallery system completely. Close drain valve and in- Water pump stall plug. 10. Prepare a mixture of radiator detergent ac- cording to the detergent manufacturing specs Draining valve and pour the solution into the radiator. FIGURE 4.46B 11. Repeat step 8, but run the engine at low idle 15. Install radiator cap.

Start engine and run it at for 30 minutes before draining and flushing. low idle for 5 minutes. Check and make sure there isn’t any leakage. 12. After flushing is completed, use teflon tape on the engine drain plug for additional seal- 16. Install engine and radiator lower covers. See ing. Install plug and tighten securely. Specifications section for proper torque val- ues. 13. Close the radiator drain valve. 17. Run engine at high idle for 5 minutes to bleed 14. Add a mixture of engine coolant according out any air from the cooling system. to the specifications indicated in the table be- 18. Return throttle to low idle and stop engine. low.

See page 4-10 for total engine cooling Wait about 3 minutes and check engine cool- capacity. ant reservoir for proper level. See Fig. 4.46C. NOTE Expected minimum temperature Long life coolant -14.5°C ( 5.9°F) 30% mixed - 34°C (-29.2°F) 50% mixed Change contaminated and foamy coolant with new cool- FIGURE 4.46C ant mixture as soon as possible. 19.Make sure to change the position of the auto Cooling water other than long life coolant should be accel connector to activate the auto accel changed two times a year, in autumn and spring. function for normal machine operation. See Figure 4.45B for better reference. REMOVE BOLTS AND COVER PLATE