Kobelco — E. MAINTENANCE ON ROLLERS AND IDLERS 4-

MAINTENANCE WARNING WEAR GOGGLES, SAFETY SHOES, HARD HAT, WORK CLOTHES AND WORK GLOVES TO PERFORM INSPECTION AND MAINTE- NANCE ON THIS MACHINE. E. MAINTENANCE ON ROLLERS AND IDLERS Change the oil in rollers and idlers every 2000 hours of machine operation. NOTE Refer to the machine’s service manual for specific instruc- tions in regards to removing and installing the undercar- riage rollers and idlers. Contact your Kobelco dealer’s Service Department for assistance if necessary. REMOVE ROLLER AND PLUG TO DRAIN FIGURE 4.52A 1. Remove rollers and idlers as indicated in the Service Manual. REMOVE ROLLER AND PLUG TO DRAIN 4 2.

Remove side plugs from upper rollers cover plate and drain the oil out into an empty con- tainer. See Figure 4.52A. 3. Remove plugs from track rollers center flanges and drain the oil out into an empty container. See Figure 4.52B. 4. Remove side plugs from idler bearing housing and drain the oil out into an empty container. See Figure 4.52C. FIGURE 4.52B 5. Remove side plugs from idler bearing housing and drain the oil out into an empty container. NOTE Use engine oil as indicated in page 4-11 and refer to page 4-10 for proper capacities to refill oil in Rollers and Idlers. 6. Install rollers and Idlers and torque properly. Refer to Specification Section for proper torque values.

REMOVE IDLER AND REMOVE PLUG TO DRAIN CAUTION Clean up all spilled oil. Dispose of all hazardous waste in accordance with government environmental regula- tions. FIGURE 4.52C 4-52 SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2