Kobelco — A. DUST SEALS 4-

MAINTENANCE 4.12 PERIODICAL INSPECTION ITEMS WARNING A. DUST SEALS Inspect dust seals in all pin connections frequently. The attachment incorporates several dust seals that should be periodically checked for damage and excessive wear. See Figure 4.53A. If exces- sive wear is found, refer to the machine’s Shop Manual for specific instructions in regards to dis- assembly and assembly. Contact your Kobelco dealer’s Service Department for assistance if nec- essary. Refer to table below for the proper part numbers for the replacement seals: WEAR GOGGLES, SAFETY SHOES, HARD HAT, WORK CLOTHES AND WORK GLOVES TO PER- FORM INSPECTION AND MAINTENANCE ON THIS MACHINE.

8 7 2 1 5 6 8 NOTE Order the following part numbers for replacement seals: 9 9 4 3 SK250(LC)-VI SK250NLC-VI FIGURE 4.53A 4 2445R220D9 (2 Req’d) LIP OUT 2445R220D6 (2 Req’d) 2445R220D3 (2 Req’d) BOSS 2445R220D4 (4 Req’d) 2445R220D6 (2 Req’d) 2438U999S26 (2 Req’d) 2438U999S26 (2 Req’d) 2438U1381S24 (4 Req’d) 2438U959S23 (4 Req’d) BUSHING SEAL Use Figure 4.53B as reference to install the seals. Make certain that pin surface and tapered end are smooth and free from burrs or imperfections that could cause damage to the new seals.

FIGURE 4.53B SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2 4-53 NO COMPONENT LOCATION SK210(LC)-VI 1 BOOM FOOT 2445R220D6 (2 Req’d) 2 ARM TO BOOM 2445R220D6 (2 Req’d) 3 ARM TO IDLER LINK 2445R220D3 (2 Req’d) 4 BKT CYLINDER TO BUCKET LINK 2445R220D4 (4 Req’d) 5 ARM TO BUCKET 2445R220D4 (2 Req’d) 6 BOOM CYLINDER HEAD 2445R138D8 (2 Req’d) 7 BOOM CYLINDER ROD 2438U941S3 (2 Req’d) 8 ARM CYLINDER HEAD AND ROD 2438U1106S6 (4 Req’d) 9 BKT LINK (AT BUCKET) 2438U1109S28 (4 Req’d)