MAINTENANCE C. CHANGE SLEWING RING GREASE BATH Change the slewing ring grease bath every 2000 hours of machine operation. To properly replace the grease, it is necessary to remove the upper frame. Refer to the machine’s shop manual and/ or contact your Kobelco dealer’s Service Depart- ment for assistance. Proper tools have to be used and specific instructions must be followed to undeck the machine upper structure from the ist lower structure. See Figure 4.58A. CLEAN & FILL WITH MoS2 GREASE CAUTION If the slewing ring ever becomes submerged in water, it is mandatory that the sump bath grease be changed.
FIGURE 4.58A SK32004129 SUMP BATH GREASE QUANTITIES CHART 4 If the machine is in the field and can’t be brought to a shop to replace the slewing ring grease bath, proceed to remove the swing motor assembly. Use eye bolts P/N ZS91C01200 on top cover of the swing motor and a proper lifting device to remove the swing motor assembly. Refer to the end of Section 6 to obtain the proper caps and plugs for lines and hoses that need to be removed during this process, see Fig. 4.58B. D. WINDSHIELD WASHER RESERVOIR Fill the windshield washer fluid reservoir as re- quired using approved windshield washing fluid. 1. Open engine air cleaner access door to locate washer fluid reservoir. See Figure 4.58C.
2. Pull cap off and fill with proper windshield wash- ing fluid. 3. Replace cap and reposition engine air cleaner access door. Install 2 eye bolts ZS91C01200 (Lifting cap. 220 Kf) Apply loctite # 262 and torque to 55 +6 Kg-m (397 +43 Ft-lbs) FIGURE 4.58B WARNING MAKE SURE TO BLOCK THE ATTACHMENTS PROP- ERLY BEFORE PROCEEDING TO REMOVE SWING REDUCTION UNIT. FIGURE 4.58C 4-58 SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2 CAUTION INSTALL PROPER CAPS AND PLUGS ON HOSES TO HELP PREVENT CONTAMINATION FROM ENTERING THE HY- DRAULIC SYSTEM. GREASE TYPE SK2 10(LC)-V I SK250(LC)-VI, SK250NLC-VI N.L.G.I. No. 2 LITHIUM BASE W/MoS2 (1 8.3 kg 8.3 lbs) 11.3 kg (24.9 lbs) WINDSHIELD WASHER RESERVOIR