Kobelco — 5. Bucket Teeth and Side Cutters 4-

MAINTENANCE 5. Bucket Teeth and Side Cutters Frequently, check bucket tooth points and side cutters for wear and looseness. The life of the bucket teeth and side cutters can not be deter- mined by working hours, but rather by applica- tion and operating conditions. WARNING WEAR GOGGLES, SAFETY SHOES, HARD HAT, WORK CLOTHES AND WORK GLOVES TO PER- FORM INSPECTION AND MAINTENANCE ON THIS MACHINE. a. Parts description, see Figure 4.57A: (1) adapter nose, (2) tooth point, (3) rubber lock pin, (4) locking pin, (5) side cutter, (6) cap screw, (7) Nut. NOTE Contact your Kobelco dealer for assistance in regards to parts for the specific bucket installed on your machine. b.

Replace the bucket teeth when their cutting edge and/or when hole for retaining pin on tooth are excessively worn. b.1- Place a wood block under the bucket teeth support lip, as indicated in Figure 4.56B, and remove all sand and soil ad- hered to the teeth pin connection areas. b.2- Use a hammer and a punching tool to hammer out the locking pin. Be careful not to damage the rubber lock. b.3- Inspect the lock pin (4) and rubber lock (3). Replace them if the lock pin (4) is too short or the rubber lock (3) is in poor con- dition. b.4- Clean the surface of the adapter nose (1) with putt knife. b.5- Fit the tooth point (2) onto the adapter nose (1).

b.6- Push the rubber lock pin (3) into the hole of the adapter nose (1). b.7- Hammer the locking pin (4) until it is aligned with the point surface. FIGURE 4.57A 4 WARNING DO NOT STRIKE TEETH WITH HAMMER. THIS CAN CAUSE CHIPS TO FLY CAUSING IN- JURY FIGURE 4.57B CUT BOLT HEADS c. Replacing the side cutters c.1- Remove all sand and soil adhered around the side cutters capscrews. c.2- Use a torch and cut off the cap screws, then remove the side cutters. See Figure 4.57C. c.3- Clean the mounting surface and install a new side cutter with new cap screws and nuts. See Figure 4.57D. c.4- Torque the cap screw with nuts to 100 + 5 Kgf-m (722 + 36 lbs-ft). C.5- Spot weld the nuts.

FIGURE 4.57C FIGURE 4.57D SK210(LC)/SK250(LC)–VI Dynamic Acera OM, 09/00 Rev.2 4-57