5. Clean the battery posts and cable ends by using a battery post cleaning tool and/or a wire brush to remove dirt, grease, and corrosion. 6. Connect cables to the proper terminals: positive cable to the positive terminal (+) and negative cable to the negative terminal (-). Connect the negative cable last. ! CAUTION Connecting cables in reverse (positive to negative and negative to positive) can cause serious damage to the electrical system. SPARK PLUG The ATV comes equipped with a specifi ed spark plug. See the spe- cifi cations chart for the correct spark plug. A light brown insulator indicates that the plug is correct.
A white or dark insulator indicates that the engine may need to be serviced or the carburetor may need to be adjusted. Consult an authorized Arctic Cat ATV dealer if the plug insulator is not a light brown color. To help prevent cold weather fouling, make sure to thoroughly warm up the engine before operating. To maintain a hot, strong spark, keep the plug free of carbon. Before removing the spark plug, be sure to clean the area around the spark plug. If you do not, dirt could enter engine when removing or in- stalling the spark plug. Adjust the gap to 0.7-0.8 mm for proper ignition. Use a feeler gauge to check the gap. When installing the spark plug, be sure to tighten it securely.
A new spark plug should be tightened 1/2 turn once the washer contacts the cylinder head. A used spark plug should be tightened 1/8 - 1/4 turn once the washer contacts the cylin- der head. 80