ENGINE IDLE RPM ADJUSTMENT To properly adjust the idle, a tachometer is necessary. If one is not available, take the ATV to an au- thorized Arctic Cat ATV dealer. To adjust idle RPM: 1. Start the engine and warm it up to normal operating tempera- ture. 2. Turn the idle adjustment screw in or out until the engine idles at 1250-1350 RPM. ! WARNING Adjust the idle to the correct RPM. Make sure the engine is at nor- mal operating temperature before adjusting the idle RPM. THROTTLE CABLE ADJUSTMENT To adjust the throttle cable freeplay: 1. Slide the rubber boot away; then loosen the jam nut (1) from the throttle housing. 2.
Turn the throttle cable adjuster (2) until the throttle lever has pro per free-play of 3-6 mm (1/8 - 1/4 in.). 3.Tighten the jam nut (1) against the throttle housing securely; then slide the rubber boot over the adjuster. GENERAL MAINTENANCE AIR FILTER (Engine) The air fi lter inside the air fi lter housing must be kept clean to provide good engine power and gas mileage. If the ATV is used under normal conditions, service the fi lter at the intervals specifi ed. If operated in dusty, wet, or muddy conditions, inspect and service the fi lter more frequently. Use the following procedure to remove the fi lter and in- spect and/or clean it. !
CAUTION Failure to inspect the air fi lter frequently if the ATV is used in dusty, wet, or muddy conditions can damage the engine. 81