Arctic Cat GmbH — 400 ENGLISCH

! CAUTION When replacing the headlight bulb, be careful not to touch the glass portion of the bulb. Grasp the new bulb with a clean cloth. Registration Plate Light To replace the taillight bulb, use the following procedure: 1. Remove the two screws and remove the lens. 2. Pull out the bulb. 3. Install the new bulb by pushing it in. 4. Install the lens. Tighten the two screws securely. KM143B Turning Light or Taillight/Brakelight To replace the turning light or taillight/brakelight bulb, use the follo- wing procedure: 1. Rotate the socket counterclockwise and remove it from the housing. 2. To remove the bulb from the socket, push in and rotate counterclockwise. 3.

To install the bulb, push in and turn clockwise. 4. Insert the socket into the housing and rotate it clockwise. FUSES The main fuse is located under the seat near the battery. The fuses are located in a power distribution module in front of the steering post under the electrical access panel. If there is any type of electrical system failure, always check the fuses fi rst. n Note: To remove the fuse, compress the locking tabs on either side of the fuse cover and lift off; then remove and replace the fuse. 86