. OPERATION EXPLANATION OF COMPONENTS ACCUMULATOR, HANDLING WARNING The accumulator is a device to store the pressure in the control circuit, and when it is installed, the control circuit can be operated for a short time even after the engine is stopped. Therefore, if the control lever is moved in the direction to lower the work equipment, it is possible for the work equipment to move under its own weight. The accumulator is installed in the position shown in the diagram on the right.
3 - 66 On machines equipped with an ac cumulator, for a short time after the engine is stopped, if the work equipment control le ver is moved to the LOWER position, the work equipment will move down under its o wn weight. LOCK position. After stopping the engine, always place the safety lever and parking lever in the The accumulator is charged with h igh-pressure nitrogen gas, so improper operation may cause an e xplosion which will l ead to serious injury or damage. When ha ndling the accumulator, always do as follow s. Pressure in the control circuit c annot be completely removed.
When removi ng the hydraulic equ ipment, do not stand in the direction that oil spurts out whe n performing the operation. lator. pose of it in fire. it. to any impact. ator, the gas must be released. Contact your Komatsu distributor for proper disposal. Loosen the bolts slowly. Do not disassemble the accumu Do not bring it near flame or dis Do not make holes in it or weld Do not hit it, roll it, or subject it When disposing of the accumul ator, the gas must be released. Contact your Komatsu distributor METHOD OF RELEASING PRESSURE IN OPERATING CIRCUIT ON MACHINE EQUIPPED WITH ACCUMULATOR 1. Lower the work equipment 2.
After stopping the engine, the front, rear, left, and right equipment circuit. However, the pressure ca accumulator in the work eq the screws slowly, and ne out. 1. Lower the work equipment 2. After stopping the engine,