Komatsu — RIPPER OPERATION

. OPERATION OPERATION the shank completely to the ground. 2. Operate the pin-puller control switch to remove the mounting pin. 3. Raise or lower the ripper to set the shank to the desired position. control switch to "Push in" and move the ripper up or down slowly. prevent wear of the shank. REMARK If the mounting pin cannot be removed by operating the switch, move the ripper slightly up or down and tilt it. This will make it possible to remove the pin. 3 - 112 OPERATING O When using the v ariable ripper, adj ust the length of the t ilt cylinder to select dimensi Slope face: Slopi ng face, such as o METHOD OF OPERATING PIN PULL This operation is used only when a giant r ipper i s instal 1.

Stop the ma 4. Operate the p in-puller control sw itch to insert the mo unting pin. hole in the shank a re not a ligned , set th e pin puller rting the pin in a h igher h ole in t he sha nk in order t deep ripping operations , use a long p rotector to