Komatsu — OPERATING METHOD FOR RIPPING OPERATIONS

. OPERATION OPERATION OPERATING METHOD FOR RIPPING OPERATIONS BASIC OPERATING METHOD REMARK will be no operation. 3 - 113 TRACK OF RIPPER SHANK Carry out the ripping opera tion as follows, p assing th rough the points shown in the diagra (1) Til t the ripper back, low er the ripper poin t to the gr ound that the pla ce to begin ripping, and raise the rear of the machine.

(2) To press the decelerato r pedal and lowe r the engin e speed, set the speed range to F1, a nd tilt the ripper to insert the point to the specifie (3) When the ripper point r eaches the specified depth , raise the engin e speed to full speed Til t th e shank and carry If t he circuit is relieved reduc e the ripping dept (4) After c ompleting the rip ping, travel forward, raise t he shank from t he bed rock, then tra (5) While traveling in rever se, tilt the ripper back, and ng point for the rippin g is reached, lower the ripper. If t he r ipper is applied w ith the rear of th e machine the ground, the drawbar pull will be low, s o the rippi will be reduced.

ripping depth If the unevenness, and this w