Komatsu — OPERATING METHOD FOR RIPPING OPERATIONS

. OPERATION OPERATION RIPPING BY CLIFFS REMARK In the case of the multi-shank ripper, carry out ripping at right angles to the slope face. and carry out ripping. 3 - 114 When carrying out ripping at the edge of a cliff, tilt the ripp er back to make depth (L) longer Depress the decelerator pedal, drive slowly forward, an d when the ripper point contacts RIPPING BY SLOPE FA CES (Giant ripper) When carrying out ripping the ripper tilt back angle work at the edge of slope face small, and if there is an area w s, make here the slope face has not been ripped, apply the ripper diagon ally.

Cross ripping On jobsites with hard bed rock, for rocks and boulders w hich are impossible to break or dig up with one ripping pass, carry out the second ripping pass at ri ght angles to the first ripping d irection. At the edge of cliffs, whe a cross direction, make t re it is impossible to apply the he space between the shanks ripper in smaller During the ripping operat ion, if there is any hard bedroc k, carry out ripping in the opposit e direction from the direction w here the ripper was applied. If it i s still impossible to break up t he rock, break up the area aroun When carrying out conc d the bedrock a little at the tim entrated ripping of hard bedr e.

ock, the work efficiency is high if t he ripper is applied to the who le of the digging face.