. OPERATION TROUBLESHOOTING 3 - 143 PRECAUTIONS WHEN CHARGING BATTERY When charging the ba ttery, if the battery is not han dled correctly, ther e is danger that th e battery may explode. Alw ays follow the instructions in "IF BA TTERY IS DISCHARGED ( PAGE 3-142)" and the instruction ma nual accompanying the char ger, and do as follows. Set the voltage of th e charger to match the voltag e of the battery to be charged. If the correct voltage is not selecte d, the charger may overheat and c ause an explosion.
ve (+) charger clip of the c harger to the Connect the positi positive (+) terminal of the battery, then connect t he negative (-) charger clip of the charger to the negative (-) t ix the clips securely. battery. Be sure to f Set the charging cu rrent to 1/10 of the value of th e rated battery capacity; when car rying out ra pid chargin g, set it to less than the ra ted battery capacity. If the charger curren t is too high, the electrolyte wi ll leak or dry up , and this m ay caus e the battery to catch fi re and explode. If the battery electr olyte is frozen, do not charge the battery or start the engine with a different power source.
hat this will ignite the battery electrolyte and cause the battery to explode. If There is a hazard t hat this will ignite the battery electrolyte and cause the battery t o explode. STARTING ENGINE WITH BOOSTER CABLE When starting the eng ine with a booster cable, do a REMOVAL AND INSTALLATION OF BATTERY 1. Open the battery cover (1). 2. Before removing the battery, remove the ground cable (normally connected to the negative (-) terminal). If any tool touches between the positive terminal and the chassis, there is danger of sparks being generated. Loosen the nut of the terminal and remove the wires from the battery. 3. When installing, connect the ground cable last.
Insert the terminal cable on the battery, then tighten the nut. Tightening torque: 9.8 - 19.6 N·m (1.0 - 2.0 kgf·m, 7.2 - 14.5 lbft) 1. Open the battery c 2. Before removing (normally connect touches between t danger of sparks terminal and remo 3. When installing, c Insert the terminal Tightening torque: 1. Open the battery c 2. Before removing (normally connect al). If any tool touches between t he positive terminal and the c hassis, there is danger of sparks being generated. Loosen t he nut of the . hten the nut. terminal and remo ve the wires from the battery 3. When installing, c onnect the ground cable last. Insert the terminal cable on the battery, then tig Tightening torque:
9.8 - 19.6 N·m (1.0 - 2.0 kgf·m, 7.2 - 14.5 lbft) 4. Close battery cove