. OPERATION TROUBLESHOOTING 3 - 150 ENGINE ( ) : Always contact your Komatsu distributor when dealing with these items. In cases of abnormalities or causes which are not listed below, contact y ou r Komatsu distributor for repairs.
Problem Main causes Remedy Engine oil pressure caution lamp flashes when engine speed is raised after completion of warm-up Add oil to specified level, see CHECK BEFORE STARTING Replace cartridge, see EVERY 500 HOURS SERVICE ( Check, repair) ( Replace lamp) Cooling water level low, water leakage Loose fan belt Dirt or scale accumulated in cooling system Red range of water temperature gauge flashes Clogged radiator fin or damaged fin Defective thermostat Loose radiator filler cap (high altitude operation) Defective monitor panel WHEN REQUIRED Clean or repair, see WHEN REQUIRED ( Replace thermostat) Tighten cap or replace packing ( Replace monitor panel) White range of water temperature gauge flashes Defective thermostat Defective water temperature gauge ( Replace thermostat) ( Replace water temperature gauge) Engine does not start when starting motor is turned Lack of fuel Air in fuel system No fuel in fuel filter Starting motor cranks engine sluggishly Glow signal does not glow red Defective compression Defective valve clearance Add fuel, see CHECK BEFORE STARTING Repair place where air is sucked in ( Fill fuel filter with fuel, see EVERY 500 HOURS SERVICE) See ELECTRICAL SYSTEM See ELECTRICAL SYSTEM ( Adjust valve clearance) Exhaust gas is white or blue Add oil to specified level, see CHECK BEFORE STARTING Change to specified fuel Exhaust gas occasionally turns black Clean or replace, see WHEN REQUIRED ( Replace nozzle) ( Adjust valve clearance) Combustion noise occasionally makes breathing sound Defective nozzle ( Replace nozzle)