Komatsu — GUIDES TO MAINTENANCE

. MAINTENANCE GUIDES TO MAINTENANCE mounting 4 - 3 DUSTY WORKSITES: do as follows: monitor frequently to see if the air cleaner is clogged. t a shorter interval than specified. tly to avoid clogging. frequently. specially the starting motor and alternator, to avoid accumulation of dust.

When working at dusty worksites, Inspect the air cleaner clogging monitor frequently to see if the air clean er is c logge Clean the air cleaner element a Clean the radiator core frequen Clean and replace the fuel filter Clean electrical components, e specially the starting motor and alternato r, to a void a ccumulatio n of dust When inspecting or changing th e oil, move the machine to a place that i s free of dus t to prevent dirt from getting into the oil. AVOID MIXING OILS: If a different brand or grade of oil h as to be added, drain the old oil and repla ce all t he oil with the new brand o r grade of oil. Never mix different brand o r grade of oil. LOCKING INSPECTION COVERS:

nto position with the lock bar. If inspection or maintenance is performed with Lock inspection cover securely i with inspection cover not locked in po injury to the worker. sition, there is a hazard that it may suddenly blown shut by the wind and cause lown shut by t win d an BLEEDING AIR: When hydraulic equipment has be en repaired or replaced, or the hydraulic piping has bee n removed and i nstalled again, the air must be bled fro m the circuit. For details, see "PROCEDURE FOR BLEEDING AIR FROM 40)". LEEDING AIR HYDRAULIC CIRCUIT (PAGE 4- PRECAUTIONS WHEN INSTALLIN G HYDRAULIC HOSES: ons where there are O-rings or gasket seals, clean to forget to assemble the O-rings and gaskets.

When removing parts at locati replace with new parts. When doing this, be careful not to forget to assemble the O-rings and g askets When installing the hoses, do n ot twist or bend them into loops with a s mall ra dius. This will cause damage to the hose and drastically reduce its service lif e. clean the surface, and CHECKS AFTER INSPECTION AN D MAINTENANCE: If y ou forget to perform the checks after inspection and maintenance, unexpected problems may occur, and t his may lead to serious injury or property d amage. Always do the following: gine stopped) intenance points been forgotten? ntenance items been performed correctly?

Checks after operation (with en Have any inspection and ma Have all inspection and mai Have any tools or parts bee inside the machine and get Is there any coolant or oil le Have all nuts and bolts been Have any inspection and ma Have all inspection and mai ntenance items been performed correctly Have any tools or parts bee n dropped inside the machine? It is particularl y dangerous i f parts are d ropped caught in the lever linkage mechanism. aks? tightened? en operating the engine, see "PROPER TOOLS (PAGE 2-31)" and pay careful tenance items working properly? or oil when the engine speed is raised? Checks when operating engine For details of the checks wh attention to safety.

Are the inspection and main Is there any leakage of fuel For details of the checks wh Are the inspection and main Is there any leakage of fuel TOO LS (PAGE 2-31)" and pay careful