Komatsu — CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT

. MAINTENANCE SERVICE PROCEDURE CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT WARNING NOTICE CLEANING OR REPLACING OUTER ELEMENT NOTICE Before and after cleaning the element, do not leave or keep it in direct sunlight. 1. Remove 6 hooks (2), then remove cover (3). Remove outer element. 4 - 23 Always wear protective gla sses,dust mask,or other protective equipment. When removing the air cle aner element from the air cleaner bo dy,it is dangerous to pull it out by fo When working at high plac es or where the foothold is poor, be careful not t o fall because of the rea ction when pulling out the outer element.

CHECKING When the yellow piston ins ide red zone (A) of the dust indic ator (1) overlaps the red zone, clean the air cleaner element. After utton. cleaning, press the reset b Always wait for the yellow pis zone on the outside before cl ton in the dust indicator to overlap the red eaning the element. uently before the yellow piston in the dust If the element is cleaned freq indicator overlaps the red zo unable to display its normal become poor. ne on the outside, the air cleaner will be performance and the cleaning effect will In addition, the frequency of dust stuck to the element falling in side the inner element during the clea ning operation will increase. .

Hold the outer elemen left and right, and rotat it out. t, rock it lightly up and down and to the e the element to the left and right to pull NOTICE Never remove the inner el failure of the engine. ement. It will allow dirt to enter and cause r other tool. uter element, cover the air connector Do not use a screwdriver o 3. After removing the o inside the air cleaner b dirt or dust from enteri . After removing the o nnector ody with a clean cloth or tape to prevent ng.