Komatsu — CHECK ELECTRICAL INTAKE AIR HEATER

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE reset it. The yellow piston will return to its original position. 4 - 24 4. Use a clean cloth or brush to remove the dirt stuck to the cover and the inside of the air cl eaner body. r (Max. 0.69 MPa (7 kgf/cm2, 99.4 5. Direct dry compressed ai PSI)) from the inside of the direct the compressed air f again from the inside. 1) Check that the inner insert it securely. 2) If the yellow piston ov immediately after the o inner and outer eleme outer element along its folds. Then rom the outside along the folds, and element is not loose. If it is loose, erlaps the outer element red zone uter element is cleaned, replace the nts.

cover installed in Step 3. 6. Remove the cloth or tape 7. If small holes or thinner p arts are found on the element when it is checked with an elec replace the element. tric bulb after cleaning and drying, NOTICE Do not use an element whose f When cleaning the element, do 8. After replacing the elemen t, press the dust indicator button to REPLACING INNER ELEMENT 1. First remove the outer el element. 2. Cover the air connector si tape. 3. Clean the air cleaner bo installed in Step 2. 4. Fit a new inner element to Do not clean and reinstall ement, and then remove the inner 2. Cover the air connector si de (outlet side) with a clean cloth or dy interior, then remove the cover the connector.

a inner element. CHECK ELECTRICAL INTAKE AIR HEATER starts (once a year). Check before the cold season Remove the electric heater fro m the engine intake manifold and check for wire disconne ctions and dirt clung When checking and installing the electric heater, replace its gasket with a new part.