. MAINTENANCE SERVICE PROCEDURE CHECK TRACK TENSION with the transmission in value, adjust it in the ADJUSTMENT WARNING under high pressure. Grease penetrate the body, causing WHEN INCREASING TENSION 4 - 25 The wear of pins and bushings on the un dercarriage will vary with th e working conditions an d types of soil. It is thus necessar y to continually inspect the trac k tension so as to maintain the standard tension. Carry out the check and adjustment un der the same conditions as becomes clogged with mud, measure w INSPECTI ON machine on level ground (stop Stop the FORWA RD without applying the brake).
o n the tra ck shoes between the carrier ro in the figu grouser a re, and measure the clearance t the midpoint. If the clearance 1.18in), t he tension is standard. ck tension is not at the stand manner. If the tra following Grease ins ide the adjusting mechanism is u coming fr om plug (1) under pressure can p injury or d eath. For this reason, do not loosen D o not loo sen any part other than plug (1). Fu face in fro nt of the plug (1). If the track tension is not relieved by this pro Komatsu d istributor for repairs. 1. Rem ove 2 bolts (3), then remove co NOTICE The saf ety label is stuck on the back of co When r emoving cover (2), be careful not t 2.
Pump in grease through the grease fitting with a grease pump. 3. To ch eck that the correct tension ha s been achieved, move the machine backwards a 4. Chec k the track tension again, and i f the tension is not correct, adjust it again.