. MAINTENANCE SERVICE PROCEDURE REVERSE AND REPLACE THE END BITS AND CUTTING EDGES WARNING (Unit: mm (in)) Item Judgment standard The symbols in the Work equipment column are as follows. A: Semi U-dozer, U-dozer B: Angledozer REMARK If the cutting edge and the end bit on both sides are worn out, replace with new one. If it has been worn out up to the fitting surface, repair the fitting surface and then reverse or replace.
4 - 28 It is dangerou s if t he work equipmen t moves by mistake when the cutting edges and e nd bits are bein g reversed or replac Set th e work e quipment in a stable c ondition, then s top t h e engine and lock the b lade control lever securely with t he safet y lock lever. Reverse or r eplace the end bits and cutting edges before it is worn out t o the blade 1. Raise th e blade to a proper height, apply a bloc k under the frame to prevent the blade f rom falling 2. Operate the safety l ock leve r to t he LOCK position. 3.
Measure the wear o f the end bit and cuttin g edg e in accordance wit h the wear s tandard s given b Wear standards Position of measurement Work equipment Standard measurement Height at outside of end bit A B 415 (16.4) 292 (11.5) A 662 (26.1) 500 (19.7) Width of end bit B 435 (17.1) 3 Height at inside of end bit A B 330 (13.0) 260 (10.2) 254 (10.0) 211 (8.3) 4 Height of cutting edge (from center of mounting bolt hole to end face) A B 165 (6.5) 95 (3.7) 127 (5.0) 86 (3.4)