. MAINTENANCE SERVICE PROCEDURE and tighten the bolt temporarily. Press the blade against the ground to eliminate the play of bolt (2), then tighten the bolt to the specified torque. 4 - 29 4. Remove th e cutting edge a nd the end bit and clean the mounting surface 5. Reverse or replace the cut ting edge and the end bi t when worn out. Tightening torque for moun Semi U-dozer: 1330 - 1660 N·m (136 - 169 kgf·m, 983.7 - 1222.4 lbft) Angledoze r: 738 - 999 N·m (75.3 - 101.9 kgf·m, 54 4.6 - 737 lbft If bolt (2 ) and n ut (1) are dama ged, replace them with n ew ones at the sam e time.
Loosen nut (1) remove bolt (2) , then replace 1) I nstall t he cutting edge to the blade 2) When i nstalling end bit (3), put top face (4) of th e end bit in ight co ntact with stopp er (5), then tighten the b 6. Afte r sever al hours of runn ing, retourque