. MAINTENANCE SERVICE PROCEDURE PROCEDURE FOR BLEEDING AIR FROM HYDRAULIC CIRCUIT 4 - 40 See "OPERATION S AND C HECKS AFTE R STARTING ENGINE (PAGE 3-91)". Since the engine m ust be st arted an d the b lade mus t be operated, see O NOTICE If the engin e is run at h igh speed immediately afte r startup o r a cylinder i s pushed up to its stroke end, air taken inside the cylinder may cause damage to the pisto n packing 1. Bleeding air fro m cylind 1) Run t he eng ine at lo w idling, a nd extend and r etrac t eac h cylinder 4 to 5 times, taking care so tha t a cylinder may not be brought up to its stroke end. (Sto p the cylinder approx .
100 mm (3.9 in) short of its s troke end) 2) Next, opera te each cylinder 3 to 4 t imes to th e en d of it s stroke. 3) Finally, ope rate eac h cylinde r 4 to 5 times to the e nd of its stroke t o completely remove t he air.