Komatsu — PROCEDURE FOR RELEASING INTERNAL PRESSURE IN HYDRAULIC CIRCUIT

. MAINTENANCE SERVICE PROCEDURE PROCEDURE FOR RELEASING INTERNAL PRESSURE IN HYDRAULIC CIRCUIT WARNING Fuel control (1 place) 4 - 41 The hyd raulic system is always under internal pressure, s o when inspecting or rep lacing the piping or hoses, always release the pres sure in the circuit befo re starting. If the p ressure is not r eleased, high pre ssure oil may spurt out and cause serious persona The part s and oil are at high te mperature after the engine is stopped, and may caus e serious burns. Wait for t he temperature to go do wn before starting the When th e oil filler cap is remov ed, oil may spurt o ut, so t urn the cap slowly to rele ase the pressure before rem oving the cap. 1.

Stop t he machine on firm l evel ground. nd, then stop the engine. ressure, operate the blade control 2. Lower the blde to the grou nd, then stop th e engin 3. To re lease the internal p ressure, operate the b ontrol lever i after s n each direction to th e end of its strok e within 15 seconds topping the engine. 4. Loose releas n oil filler cap (F) at t e the internal pressu he top of the hydraulic tank slowly to re. 5. Start t he engine, run it at lo w idling for approx. 5 se conds , then stop t to the Re the he engine and opera te the work equipment control lever front, rear, left, and right. peat the above Step 3 2 - 3 times to comple tely remove remaining pressure . LUBRICA 1.

Lower the work equipmen t to the ground, t hen sto p the 2. Using a grease pump, pu mp in grease through th e grease f ittings shown 3. After greasing, wipe off an y old grease tha t was p ushed out