. MAINTENANCE SERVICE PROCEDURE REPLACE EXTRA FUEL FILTER CARTRIDGE (WHEN EQUIPPED) WARNING 4 - 54 After the eng ine has been operated, all parts are at high temperature, so do not replace the filter imme diately. Wait for all parts to cool dow n before starting the operation. High pressu re is generated inside the engin e fuel piping system when t When replac ing the filter, wait for at least 3 0 seconds after stopping th e engine to let the internal p ressure go down before replacing th Do not bring NOTICE Genuine Ko matsu fuel filter cartridges use a special filter that has hig hly efficient filtering ability. When replacing the filter cartridge, al ways use a genuine Komatsu p art.
The commo n rail fuel injection system use d on this machine consists of more precise parts than th e conventional injection pump and n ozzle. If any part ot her than a genuine Komatsu filt er cartridge is used, dust or dirt may get in and cause pro blems with the injection system. Alw ays avoid using substitute par ts. When carryi ng out inspection or maintenan ce of the fuel system, pay m ore attention than normal to t he entry of dirt. If dirt is stuck to any part, use fuel to wash it off co mpletely. Container t o catch the oil ch Filter wren 1. Set the co cartridge. 2. Using a fi to remove 3. After rem installed t cup is use 4. Install cu cartridge. new part. Cup tig 5.
Clean the coat the p the filter h 1. Set the co ntainer to catch the fuel und er the additional fuel filter 2. Using a fi lter wrench, turn filter cartrid ge (1) counterclockwise it. oving the cartridge, turn cup ( 2) of the water separator o the bottom of the cartridge counterclockwise. (This d again.) p (2) to the bottom of the new additional fuel filter (When doing this, always replace the O-ring with a ) htening torque: 10 N·m (1.0 kgf·m, 7.2 lbft) htening torque: 10 N·m (1.0 5. Clean the filter holder, fill the new filter cartridge with clean fuel, acking surface thinly with engine oil, then install to older.