. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE 4 - 55 When adding fuel, do not remove cap (B). Always add fuel f rom the 8 small holes (A) on the dirty side. ove cap (B) and install the fuel filter. After a dding fuel, rem ove cap (B) and install Alway s fill with clean fuel. Be careful not to let any dirt or du st get into the fue l. In particular, center portion is the cl ean side, so do n ot remove cap (B ) when adding f uel. Be careful not to le t dirt or dust get i nto center portio n on the clean s 6.
Whe n installing, ti ghten until the packi ng surface con tacts the seal s urfac e of the filter ho lder, then tighten it up 1/2 t o 3/4 of a tur If th e filter cartridg e is tightened too fa r, the packing will be damage d and this wi ll lead to leakage of f uel. I f the filter cartridge is t oo loose, fuel will als o leak from the packing , so a lways tighte n to the correc W hen tightenin g with a filter wrench , be extremely careful n ot to dent o r damage the 7. Afte r completion o f the replacement o f fuel filter cartr idge (1), bleed the a Blee d the air as fo 8. Add fuel to the fu el tank until full (to F ULL mark on th e fuel gauge). 9.
Afte r replacing filt er cartridge (1), loos en air bleed plu g (3) and add fuel u ntil no more bu bbles come out i n the fuel from the air b 10. Afte r replacing the filter cartridge, start the engine an d check f or any leakage of f uel from the fi lter sea l surface.