. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE REMARK 4 - 58 2. Taking car e not to get oil over yourself, remove drain plug (P slowly, the n loosen drain valve (2) and drain the oil. Be careful not to loosen the drain valve too much and deform the stopper are excessive meta 3. Check the particles o 4. distributor. Tighten dra Tightening torque for drain plug (P): 68. kgf· Tightening torque for drain valve (2): 63 1.5 .7 ± 14.7 N·m (6.5 ± kgf·m, 47 ± 10.8 lbft 5. Using the fi lter wrench, turn full-flow filter cartridge (3) to the lef and remov e it. t getting oil on yourself, do not carry out this om immediately under the cartridge.
To preven operation fr om immediately under the c 6. Clean the fi lter holder, fill the new filter ca rtridge with engine oil coat the pa cking surface and thread wit h engine oil (or coat i thinly with grease), then install the filter cartridge. Check that the old packing is not stuck to the filter holder. If the old packing is stuc k to the holder, it will cause o 7. When insta lling, bring the packing face i nto contact with the fi lter holder, then tighten a further 3/4 - 1 turn. he filter. When u sing a filter wrench to tighten , be extremely carefu l not to damage or dent t 8.
After replac ing the filter cartridge, add e ngine oil through oil fi ller port (F) so that the o il level is between the H and L mark s on dipstick (G). 9. Run the en gine at idling for a short time, then stop the engine, and check that the oil le vel is between the H and L marks on the dipstick. For details, see "CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL (PAGE 3-73)".