. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE gas color, contact your 4 - 70 3) Lo be 3) Lo wer cover (2) gradually and open it. Drain plu g (P) can seen at th e top. 3. Remo ve dipstick (G), then rem ove drain plu g (P) and drain the oil. raining the oil,tighten drain plug (P). After d raining the oil,tighten dr 4. Add e ngine oil th rough the hol der of dipstic k (G). Aft er adding the oil , insert dip stick (G). 5. Remo ve any dirt or dust stuck to breather ( 5), then w ash with clean diesel oil or flushing oil.If completely, repla ce with a new part. 6. Install undercove se engine si left sid e of the m (1) at the CHECK PIVOT BEARING OIL LEVEL, ADD OIL 1. Remove plug (1).
2. Check that the oil level is up to the oil level (25 mm (1.0 in)) shown in the diagram. If the oil level is low, add engine oil through the hole of plug (1). 3. Install plug (1). 1. 2. 3. 1. Remo ve plug (1) 2. Check that the o shown in the dia throug h the hole 3. Install plug (1). in)) ngin oil CHECK INJECTOR Check the color of t he exhaust gas visually. If there is any abnormality in the exhaust or inspection. UBLESHOOTING (PAGE 3-139)" "Exhaust color is black". Check the Komatsu distributor f or inspection. For details , see "TRO UBLESHOOTING (PAGE 3-139)" "Exhaust color i