. SAFETY PRECAUTIONS FOR OPERATION the If 2 - 23 TRAVELING ON SLOPES ping over or slipping to the side, always do as follows. p the blade approxmately 20 to ground. In case of emergency, e ground to help the machine to use the engine as a brake, if wn a slope. Traveling at an angle ely dangerous. l across slopes. Always go down osition of the machine, then travel es, or wet steel plates with low pes there is a hazard that the veling downhill or travel downhill al. If this is neglected, the engine that is dangerous. Be sure to set e lower gear speeds. In addition, ngine as a brake, if necessary. ound, lower the travel speed.
To prevent the machine from tip ping over or slipping to the side, always do as follow When traveling on slops, kee 30cm (8 to 12in) above the quickly lower the blade to th stop. Apply the brake and necessary. Always travel straight up or do or across the slope is extrem Do not turn on slopes or trave to a flat place to change the p on to the slope again. Travel on grass, fallen leav speed. Even with slight slo machine may slip.
Do not shift the gear while tra with the transmission in neutr does not work as a brake, and the transmission in one of th apply the brake and use the e When turning on a downhill gr PROHIBITED OPERATIONS To make it easier to escape if there is any problem, set the tracks at right angles to the road shoulder or cli the sprocket at the rear when carrying out operations. When operating the machine, take care that it will not exceed its performance valu es such as stability, max using load, etc. to prevent rolli work equipment. ng of the machine caused by an overload and disast ers caused by breakage USING BRAKES When the machine is traveling , do not rest your foot on the brake pedal.
If you trav el with your foot resting o pedal, the brake will always b e applied, and this will cause the brakes to overhea t and fail. Do not depress the brake ped al repeatedly if not necessary. If this is neglected, the brake will be overheate will not work when required. the braking force of the engine, and always use the right brake pedal. When traveling downhill, use the braking force of the engine, and always use the OPERATE CAREFULLY ON SNO W Snow-covered or frozen surfa ces are slippery, so be extremely careful when trave ling or operating the ma and do not operate the levers careful when working on slo suddenly. Even a slight slope may cause the machine to slip, so be partic pes.
the ground becomes soft when the temperature rises, and this may caus With frozen ground surfaces, machine to tip over. If the machine enters deep sn ow, there is a hazard that it may tip over or become buried in the snow. Be c not to leave the road shoulde r or to get trapped in a snow drift. When clearing snow, the road shoulder and objects placed beside the road are bur ied in the snow and can seen. There is a hazard of th carefully. e machine tipping over or hitting covered objects, so always carry out oper When traveling on snow-cover ed slopes, never apply the brakes suddenly.
Reduce the speed and use the e as a brake while appling th necessary, lower the blade to e foot brake intermittently (depress the brake intermittently several time the ground to stop the machine.